Welcome to Erica's Craft Room
25 Days of Christmas,
with 25 Cricut projects a day.
Don't forget to stop by Erica's blog to see 24 more projects today....
and every day in December.
For my project I made 2 ornaments. The first ornaments I made using Winter Lace and Vinyl.
Vinyl is really easy to cut on the cricut, not so easy to put on a round ornament. I found that the more delicate snowflakes were much easier to place on the ornament than the more full shaped ones.
First I took my ornaments and filled them with Delta Creamcoat Varnish. It is pretty thick but it works, it probably just takes a lot longer to let the varnish drip out than if you used the floor stuff. I wasn't very patient and probably should have let the excess drip out longer. I then poured in Martha Stewart Blue Sapphire Glitter and let it dry.
To cut out the vinyl snowflakes I used the kiss cut. The kiss cut means you do not cut through the backing paper and that makes it much easier to work with. I used Stampin Up Vinyl and their transfer paper.
I cut Accent 4 at 2.11 x 2.417 and Snowflake 6 at 2.22 x 2.417. I also tried to cut Accent 6 and Star and those were a major pain to put on the ornament. I set my expression at Blade 3, Speed 1 and Pressure 2. Once it is cut, you get to pick out all the tiny pieces so that the only thing left on the backing is the snowflake. I cut a piece of transfer paper to fit the snowflake and placed it sticky side down on my snowflake and went over it with my scissors handle to make sure the transfer paper was stuck to the snowflake. Now remove the backing paper and you are ready to carefully place the snowflake on the ornament. It works best to start from the center and work your way out.
I then added a beaded hanger that I made a few years ago and pulled some thick silver tulle through the top of the ornament and tied a knot.
My 2nd Ornament is a Baby's First Christmas Ornament.
I used a block from a set that I picked up at Salvation Army. I sanded the paint to rough it up and then used a thin coat of Modge Podge to adhere paper from Recollections Holiday Traditions 4.5 x 6.5 paper pack. I use pieces that are cut a bit bigger and I then cut the paper off using a finger nail file. I like the sanded edges but I had to be more careful this time because of the photo printed on photo paper would not appreciate being sanded. After all the pieces were attached I went over all the edges with Walnut Distress Ink.
I then cut out a tiny 1st using A Child's Year cut at .569 x .833 welded and Stamped Christmas on the block. The tree is from Winter Frolic (Tree 3-s) cut at 1.125 x 1.736. I then cut 2- 2010 from George and Basic Shapes at 1.569 x .944 out of gold paper to use as a charm for the ornament.
To finish the ornament I screwed a tiny screw eye into the center of the block then attached the charm using a couple of jump rings and tied a bow and a hanger using some gold ribbon.
I'm not sure how this will hold up over time. I would like to put a protective finish on it, but I am not sure what I should use. If you have an idea, I would love to hear about it in a comment.